本文二维码信息
二维码(扫一下试试看!)
纸浆纤维种类和性质对其凝胶点浓度的响应关系研究
Study on the Response Relationship Between the Types and Characteristics of Pulp Fibers and Their Gel Point Concentrations
收稿日期:2023-02-17  
DOI:10.11980/j.issn.0254-508X.2023.11.006
关键词:  凝胶点浓度  加拿大标准游离度  保水值  拥挤数理论
Key Words:gel point concentration  Canadian Standard Freeness  water retention value  crowding number theory
基金项目:国家自然科学基金项目(32171727、32001276)。
作者单位邮编
陈俊忠* 永发(河南)模塑科技发展有限公司,河南滑县,314100 314100
王超 永发(河南)模塑科技发展有限公司,河南滑县,314100 314100
左华伟 永发(河南)模塑科技发展有限公司,河南滑县,314100 314100
何广德 永发(河南)模塑科技发展有限公司,河南滑县,314100 314100
张文晖 天津科技大学轻工科学与工程学院,天津,300457 300457
赵涛 中国制浆造纸研究院有限公司,北京,100102
制浆造纸国家工程实验室,北京,100102 
100102
张雪 中国制浆造纸研究院有限公司,北京,100102
制浆造纸国家工程实验室,北京,100102 
100102
张红杰* 中国制浆造纸研究院有限公司,北京,100102
制浆造纸国家工程实验室,北京,100102 
100102
摘要点击次数: 641
全文下载次数: 501
摘要:本研究考察了漂白针叶木浆、漂白竹浆和漂白蔗渣浆3种纸浆纤维的沉降情况,研究了纤维种类和性质对其凝胶点浓度(Cg)的响应关系,为纸浆纤维悬浮液脱水过程中纤维网络的形成提供关键信息。结果表明,加拿大标准游离度(CSF)与Cg存在一定负相关关系;随着纤维保水值的增大,Cg总体上随之增大,并且保水值对Cg的影响受纤维种类的影响明显;随着纤维质均长度(L)的增大,Cg随之降低,当L增大至1.2 mm时,Cg基本不变;Cg的变化规律在较高长宽比(>20)下,可以采用拥挤数理论或有效介质理论解释,在较低长宽比时,2种理论均无法直接解释,还需要考虑纤维非物理性参数,如表面电荷等。
Abstract:The settlement of three pulp fibers (bleached softwood pulp, bleached bamboo pulp and bleached bagasse pulp) was compared to analyze the effects of fiber types and characteristics on the gel point concentration (Cg), further to provide the key information of fiber network during the dewatering of pulp fiber suspension. The results showed that there was a negative relationship between the Canadian Standard Freeness (CSF) and the Cg. With the increase of fiber water retention value (WRV), the Cg increased, and the effect of WRV on the Cg was affected by fiber type. With the increase of fiber length-weighted length (L), the Cg decreased. When the L increased to 1.2 mm, the Cg basically remained unchanged. The change of Cg at a high aspect ratio (>20) could be well explained by the crowding number theory or the effective medium theory. However, both theories cannot directly explain the change of Cg at a lower aspect ratio, and non-physical parameters (such as surface charge) of fibers needed to be considered.
查看全文  HTML  查看/发表评论  下载PDF阅读器