本文二维码信息
二维码(扫一下试试看!)
均质法和超声法制备NFC及其纳米纸性能研究
Preparation of NFC by Homogenizing and Ultrasonic Method and the Properties of Its Nanopaper
收稿日期:  
DOI:10.11980/j.issn.0254-508X.2016.07.004
关键词:  均质  超声  NFC  纳米纸
Key Words:homogeneous  ultrasonic  nanofibrillated cellulose  nanopaper
基金项目:国家“973”计划项目(2010CB732206);2013广东省部产学研专项资金技术前沿项目(2013B090500071)。
作者单位
姚志明 华南理工大学制浆造纸工程国家重点实验室广东广州510640 
陈 港* 华南理工大学制浆造纸工程国家重点实验室广东广州510640 
方志强 华南理工大学制浆造纸工程国家重点实验室广东广州510640 
况宇迪 华南理工大学制浆造纸工程国家重点实验室广东广州510640 
邝其通 华南理工大学制浆造纸工程国家重点实验室广东广州510640 
许雅希 华南理工大学制浆造纸工程国家重点实验室广东广州510640 
张宝军 华南理工大学制浆造纸工程国家重点实验室广东广州510640 
摘要点击次数: 6820
全文下载次数: 2026
摘要:以漂白硫酸盐桉木浆纤维为原料,进行TEMPO氧化预处理,再采用均质法和超声法及二者结合法分别制备出纳米纤丝纤维素(Nanofibrillated Cellulose,NFC),再经溶液浇铸法制备纳米纸。重点探讨了不同制备方法对NFC特性及其纳米纸性能的影响。结果表明,不同能耗下,超声2 h、4 h比均质2次、5次制备的NFC的透明性更好,长径比更大,直径更小,最小宽度可达19 nm。工艺能耗低于20 kWh时,与均质处理相比,超声处理强度(能耗)的增加更有利于纳米纸拉伸强度和透湿率的提高,同时超声2 h、4 h比均质2次、5次制备的NFC纳米纸的光学性能更好,其中超声4h制备的NFC得到的纳米纸拉伸强度与透光率最高,分别为155.8 MPa、89.45%,优于一般的聚合物薄膜,有望应用于柔性显示电子器件的基材。
Abstract:NFC was prepared by using bleached krafteucalyptus pulp as new material, it was treated with TEMPO oxidation process at first, then fibrillated by homogenizing or ultrasonic method, finally the nanopaper made of the NFC was fabricated by solution casting method. The effects of different preparation methods on the properties of NFC and its nanopaper were discussed. The results showed that under different energy consumption, NFC prepared by ultrasonic treatment 2 h and 4 h had better transparency, higher length to diameter ratio and smaller diameter than that prepared by homogenizing 2 times and 5 times, the smallest width of the fibril was only 19 nm. Compared with homogenizing treatment, the increase of ultrasonic treatment intensity (energy consumption) was more advantageous to improve the tensile strength and water vapor permeability of the nanopaper when process energy consumption was lower than 20 kWh, moreover, the nanopaper prepared by ultrasonic 2 h and 4 h showed better optical properties than homogenizing 2 times and 5 times, the highest tensile strength and light transmittance of nanopaper was found by ultrasonic treatment 4 h, which were 155.8 MPa and 89.45% respectively and superior to the ordinary polymer film, it was expected to be applied to the substrate of flexible display electronic devices.
查看全文  HTML  查看/发表评论  下载PDF阅读器