本文二维码信息
二维码（扫一下试试看！）
活性炭负载铈催化臭氧处理桉木制浆废水
Catalytic Ozonation of Eucalyptus Pulping Effluent by Cerium Loaded on Activated Carbon
收稿日期：  
DOI：10.11980/j.issn.0254-508X.2016.03.001
关键词:  制浆废水  臭氧  催化  活性炭  铈
Key Words:pulping effluent  ozone  catalysis  activated carbon  cerium
基金项目:国家水体污染治理与控制科技重大专项(2014ZX-07213001);制浆造纸工程国家重点实验室开放基金(201356)。
作者单位
何帅明 华南理工大学制浆造纸工程国家重点实验室,广东广州,510640 
莫立焕* 华南理工大学制浆造纸工程国家重点实验室,广东广州,510640 
徐　峻 华南理工大学制浆造纸工程国家重点实验室,广东广州,510640 
李　军 华南理工大学制浆造纸工程国家重点实验室,广东广州,510640 
摘要点击次数: 7023
全文下载次数: 2094
摘要:通过浸渍法在活性炭（AC)上负载铈（Ce）制备了催化剂(Ce-AC),并用X射线衍射仪(XRD)、扫描电子显微镜(SEM)和比表面积分析仪(BET)对制备的催化剂进行表征,研究了该催化剂催化臭氧处理桉木制浆废水对CODCr和色度的去除效果。结果表明,Ce以CeO2晶型的形式负载在AC上；Ce负载量为1.0%时,Ce-AC催化臭氧处理桉木制浆废水效果最好;当反应30 min时,废水的色度和CODCr去除率达到95%和55%,分别比单独臭氧氧化过程提高10个和18个百分点,比AC催化臭氧氧化过程提高5个和12个百分点;Ce-AC催化臭氧处理桉木制浆废水极大地提高了对废水CODCr的去除率。动力学分析表明,单独臭氧氧化及AC、Ce-AC催化臭氧处理制浆废水的过程中,CODCr降解的反应符合表观二级动力学方程,负载的Ce提高了反应的动力学速率常数。
Abstract:In this work, Ce-loaded activated carbon (Ce-AC) was prepared and used as catalyst to promote COD and color removal rates of eucalyptus pulping effluent by ozone. The prepared Ce-AC was characterized by XRD, SEM and BET. Results indicated that cerium of Ce-AC existed in the form of CeO2. The best catalytic ozonation effect was found when cerium loading content was 1.0%, color and CODCr removal rates were up to 95% and 55% respectively when reaction time 30 minutes, compared with ozonation treatment alone, color and CODCr removal rates increased by 10 and 18 percentage points respectively using 1.0% Ce-AC catalytic ozonation; under the same reaction conditions; compared with using AC, using 1.0% Ce-AC as catalyst color and CODCr removal rates increased by 5 and 12 percentage points respectively. The CODCr removal rate of eucalyptus pulping effluent was greatly increased by Ce-AC catalytic ozonation. Kinetics analyses showed that CODCrdegradation followed apparent second-order kinetic equation, and Ce loading on AC increased the reaction rate constant.
查看全文  HTML  查看/发表评论  下载PDF阅读器