本文二维码信息
二维码（扫一下试试看！）
聚酰亚胺乳液的制备及其对芳纶纸的增强作用
Preparation of Water-emulsified Polyimide Resin and Its Enhancement Function on Aramid Paper-based Materials
收稿日期：  
DOI：10.11980/j.issn.0254-508X.2014.09.005
关键词:  聚酰亚胺树脂乳液  粒径  芳纶纸  增强
Key Words:water-emulsified polyimide resin  particle size  aramid paper  strengthen
基金项目:国家高技术研究发展计划（863）重大项目（2012-AA03A208）；陕西省工业攻关项目(2011K08-08)；陕西省教育厅重点实验室项目（2010JS052）资助。
作者单位
吴　珍1 1.陕西科技大学轻工与能源学院，陕西省造纸技术及特种纸品开发重点实验室，陕西科技大学教育部轻化工助剂化学与技术重点实验室，陕西西安，710021 
陆赵情1 1.陕西科技大学轻工与能源学院，陕西省造纸技术及特种纸品开发重点实验室，陕西科技大学教育部轻化工助剂化学与技术重点实验室，陕西西安，710021 
秦昀昌2 2.金东纸业（江苏）股份有限公司，江苏苏州，212132 
郝　妮2 2.金东纸业（江苏）股份有限公司，江苏苏州，212132 
摘要点击次数: 5262
全文下载次数: 1667
摘要:采用自制乳化剂A，通过相反转法制备出聚酰亚胺树脂乳液。研究了转速、乳化剂用量、温度、乳化时间对乳液的影响。结果表明，在转速为300 r/min, 温度为40℃，乳化剂浓度为23%，乳化时间为70 min的条件下，可以制备出粒径为5～7 μm的聚酰亚胺树脂乳液；采用该树脂乳液浸渍芳纶纸，芳纶纸的抗张指数、撕裂指数、耐破指数均明显提高。
Abstract:A water-emulsified polyimide resin was prepared by using phase-inversion method and chemical A as emulsifier in this experiment. The influence of stirring speed, emulsifier dosage, emulsifying temperature, and emulsifying time on emulsion particle size was studied. The results showed that the optimum conditions were water-emulsifier dosage was 23%, emulsifying temperature was 40℃ and emulsifying time was 70 min.Under these conditions, particle size of polyimide emulsion was among 5~7 μm. The application result showed that the tensile index, burst index and tear index of aramid paper increased significantly with impregnation of the emulsion.
查看全文  HTML  查看/发表评论  下载PDF阅读器