桉木化学机械浆碱木素热解特性初步研究

赵玉双; 武书彬; 郭大亮

二维码（扫一下试试看！）

桉木化学机械浆碱木素热解特性初步研究

Pyrolysis Characteristics of Alkali Lignin from Eucalyptus Mechanical Pulping Waste Liquor

收稿日期：

DOI：10.11980/j.issn.0254-508X.2012.10.007

关键词: APMP 碱木素 TG-FTIR 热解特性

Key Words:APMP alkali lignin TG-FTIR pyrolysis characteristic

基金项目:国基自然科学基金（No.21176095）；科技部“科技支撑计划”项目（No.2012AA101806）；广东省科技计划项目（No.2011A090200006）。

作者	单位
赵玉双	华南理工大学制浆造纸工程国家重点实验室，广东广州，510640
武书彬	华南理工大学制浆造纸工程国家重点实验室，广东广州，510640
郭大亮	华南理工大学制浆造纸工程国家重点实验室，广东广州，510640

摘要点击次数: 5064

全文下载次数: 1962

摘要:采用酸析法分离桉木碱性过氧化氢法（APMP）制浆废液中的碱木素，应用热重红外联用（TG-FTIR）分析方法对碱木素的热解特性进行初步研究，并对热解过程中挥发性产物释放规律进行追踪。热重分析（TG）结果表明，热解主要分为玻璃态转化、主要热解、残留物质缓慢分解3个阶段；傅里叶红外光谱（FTIR）分析结果表明，热解阶段可挥发性产物有H₂O、CO₂、CO、CH₄、酚醇类化合物和醛酮类化合物，反应时间在2000 s以后的高温阶段热解产物主要为CO和CO₂。其中，CH₄、醛酮类化合物、酚类和醇类化合物释放主要集中在300～600℃之间，且产率均较高。

Abstract:The alkali lignin was separated from eucalyptus alkaline peroxide mechanical pulping (APMP) spent liquor by acid precipitating method. Then the pyrolysis characteristics of the alkali lignin were investigated using a thermogravimetric analyzer (TGA) and the releasing mechanisms of main volatile products during pyrolysis were on-line measured by Fourier Transform Infrared (FTIR) Spectrometer. The TG results showed that the pyrolysis of alkali lignin could be approximately described by three stages, which included glass transition stage, main pyrolysis stage, and residue decomposition stage. The FTIR results indicated that H2O, CO2, CO, CH4, aldehydes and ketones, alcohols and phenols were the main volatile products at the main pyrolysis stages. CO and CO2 were main products after 2000 s. It was also obvious that CH4, aldehydes and ketones, alcohols and phenols were released concentrically in 300~600℃ with considerably high yield.

查看全文 HTML 查看/发表评论下载PDF阅读器