本文二维码信息
二维码(扫一下试试看!)
植物纤维微纤维化对纸基摩擦材料磨损性能的影响
Influences of Plant Fibre Fibrillation on the Friction and Abrasive Wear Properties of Paper-based Friction Material
收稿日期:  
DOI:10.11980/j.issn.0254-508X.2011.08.006
关键词:  纸基摩擦材料  微纤维化  磨损性能
Key Words:paper-based friction material  beating  friction properties  abrasive wear
基金项目:本课题得到国家高技术研究发展计划(863计划)重点项目(2007AA100704)及国家自然科学基金项目(30771689)的支持。
作者单位
钟林新 华南理工大学制浆造纸工程国家重点实验室广东广州510640 
付时雨 华南理工大学制浆造纸工程国家重点实验室广东广州510640 
詹怀宇 华南理工大学制浆造纸工程国家重点实验室广东广州510640 
周雪松 华南理工大学制浆造纸工程国家重点实验室广东广州510640 
摘要点击次数: 5454
全文下载次数: 2270
摘要:探讨了植物纤维微纤维化对纸基摩擦材料摩擦、磨损性能的影响。研究表明,植物纤维微纤维化对纸基摩擦材料的孔隙结构、界面结合性能及摩擦性能调节剂的留着性能产生重要影响。与未微纤维化的材料相比,低微纤维化度对材料的孔隙结构影响不大,但能有效提高填料的含量及界面结合强度,因而材料的动、静摩擦因数较高,磨损率较低。随着纤维微纤维化程度进一步提高,材料孔隙下降使得摩擦材料与对偶之间形成的润滑油膜不能得到有效抑制或破坏,并导致润滑油热交换能力不足,动、静摩擦因数降低,材料热衰退加剧,磨损率增加。
Abstract:The influence of beating of plant fibres on the friction and abrasive wear properties of paper-based friction material was investigated. Results showed that the beating of plant fibres had remarkable influence on porosity, interfacial adhesion and filler retention. The plant fibres with low beating degree had no impact on the porosity of materials, but could significantly improve the interfacial adhesion and filler retention as compared with the sample without beating, which resulted in higher friction coefficient and lower abrasion. However, in the case of high beating degree, low porosity would lead to poorer heat diffusion from the work area, which gave rise to low friction coefficient and higher abrasion of the material.
查看全文  HTML  查看/发表评论  下载PDF阅读器