|
二维码（扫一下试试看！） |
| 纤维素/ZnO复合膜的制备及其性能研究 |
| Preparation and Properties of Cellulose/ZnO Composite Film |
| 收稿日期：2019-06-30 |
| DOI：10.11980/j.issn.0254-508X.2019.10.001 |
| 关键词: 纤维素膜 ZnO 透光率 表面形态 热稳定性 |
| Key Words:cellulose film ZnO transparency morphology thermal stability |
| 基金项目: |
|
| 摘要点击次数: 4096 |
| 全文下载次数: 2414 |
| 摘要:采用醋酸锌、乙醇和乙二醇甲醚比例为1 g200 μL10 mL配制ZnO前驱体溶液，然后将其旋涂在湿纤维素膜表面，进一步通过退火处理获得性能优异的纤维素/ZnO复合膜，并以纤维素/ZnO复合膜为衬底制备透明导电膜。研究表明，提高退火温度，纤维素/ZnO复合膜的透光率呈现先降低后趋于平稳的趋势。当旋涂转速为2000 r/min，退火温度为23℃时，纤维素/ZnO复合膜的透光率高达89.6%，升高退火温度至160℃，复合膜的透光率降低至86.3%。退火温度和旋涂转速会影响纤维素/ZnO复合膜的热稳定性能，升高退火温度和旋涂转速会提高复合膜的热稳定性能。在80℃和2000 r/min的处理条件下，可以制备形貌比较均匀的纤维素/ZnO复合膜；与纤维素膜相比，以纤维素/ZnO复合膜为衬底制备的透明导电膜，其电阻降低约65%。 |
| Abstract:In order to prepare a transparent conductive film based on a cellulose/ZnO composite film, the ZnO precursor solution was prepared from zinc acetate,ethanol and ethylene glycol methyl ether based on the ratio of 1 g200 μL10 mL respectively, and then it's compounded with the cellulose film.Desirable cellulose/ZnO composite film was harvested by spin-coating and annealing treatments. The results showed that the increase of annealing temperature could slightly decrease the transparency of cellulose/ZnO composite film then following by a plateau. The cellulose/ZnO composite film presented a superior transparency of 89.6% at 23℃ of annealing temperature and 2000 r/min of spinning speed, and its transparency decreased of 86.3% due to the 160℃ of annealing temperature.In addition, both spin-coating and annealing treatments made important effect on the thermal stability of cellulose/ZnO composite film, where the thermal stability was promoted due to the improvement of annealing temperature and spinning speed. A desirable cellulose/ZnO film with uniform morphologies was prepared under the conditions of 80℃ of annealing temperature and 2000 r/min of spinning speed . |
| 查看全文 HTML 查看/发表评论 下载PDF阅读器 |