改善造纸污泥脱水性条件对CST的影响

赵骏衡<sup>1</sup>; 金海兰<sup>2; *</sup>; 李　坚<sup>2</sup>

二维码（扫一下试试看！）

改善造纸污泥脱水性条件对CST的影响

Influence of Improving Sludge Dewatering Conditions on CST

收稿日期：

DOI：10.11980/j.issn.0254-508X.2013.11.009

关键词: CST值脱水性絮凝剂造纸污泥

Key Words:CST dewater ability flocculants wastewater

基金项目:

作者	单位
赵骏衡¹	1.江原大学校山林环境科学大学造纸工学科，韩国春川，200-701
金海兰^2,*	2.东北林业大学生物质材料科学与技术教育部重点实验室, 黑龙江哈尔滨，150040
李　坚²	2.东北林业大学生物质材料科学与技术教育部重点实验室, 黑龙江哈尔滨，150040

摘要点击次数: 5493

全文下载次数: 1643

摘要:研究了改善造纸污泥脱水性条件对毛细管吸水时间（CST）的影响，结果表明，先进行300 r/min、10 min的急速搅拌，再进行50 r/min、15 min缓慢搅拌时，造纸污泥的脱水性最佳。提高废水温度，废水黏度降低，CST值也逐渐减小；pH值约为7时，CST值最低，说明中性条件可改善造纸污泥的脱水性能；高分子絮凝剂对CST值的影响表明，阳离子聚丙烯酰胺（CPAM）对提高造纸污泥脱水性优于阴离子聚丙烯酰胺（APAM）。

Abstract:CST (Capillary Suction Time) can quickly and accurately evaluate the dewatering performance of sludge. The dewatering performance of papermaking wastewater sludge was evaluated by using CST method in this study. CST values can be obtained in the tens of seconds, it can accurately reflect the sludge dewatering performance, and also can be used to determine the optimal dosage of flocculent. CST results showed that the wastewater solids had the best dewatering performance when it was rapidly stirred in 300 r/min for 10 min at first, then slowly stirred in 50 r/min for 15 min. CST values were gradually reduced with temperature increasing and viscosity decreasing; CST value was low while pH values was in 7, indicating neutral conditions probably could improve sludge dewatering performance. On the other hand CPAM was more effective than APAM for improving sludge dewatering.

查看全文 HTML 查看/发表评论下载PDF阅读器